Category: Fixture Hydraulics

 

 

 

 

Vektek at EMO 2019
Hall 5 Booth G78

In The Port Sequence Valves

Control Sequencing of Individual Devices

• Installs directly into device port, requires manifold mounting.
• Works with Top and Bottom Flange Swing Clamps, Link Clamps and High Capacity Work Supports.
• Controls timing of individual devices on your fixture.
• Each valve can be individually fine tuned from the factory preset.
• True sequencing design allows full system pressure downstream of valve after opening.
• Maintains pressure upstream while device actuates.
• Three pressure ranges available with adjustability within each range.*
• Can be added after the fixture is built to assure proper sequencing.
• Use with single or double acting clamps;
  in clamp port, unclamp port, or both.
• Internal reverse free flow check valve allows for faster return.
• Accessories available; Pressure pre-set block and in-line adapter block.

* Number of sequences within each range depends on number of devices, pump flow & operating pressure.

 

In The Port Precision Flow Control Valve

Control Speed of Individual Devices

• Use with single or double acting clamps.
• Meter-in flow control with reverse free flow check valve.
• Smallest high-pressure flow control valve on the market.
• Prevent component cam damage from unexpected or accidental surges in flow rate.
• Adjusting screw is positively retained and will not come out under pressure.
• Integral reverse free flow check valve for use with single or double acting clamps.
• Flow control requires the use of manifold mount ports.

 

For more info visit Vektek at the EMO at Hall 5, Stand G78

 

 

 

Vektek at EMO 2019
Hall 5 Booth G78

New for EMO Vektek introduces Work Supports with up to 3X capacity at 350 Bar!

Plungers stay retracted during part loading. Hydraulic pressure advances the plunger exerting only spring force as it makes contact with the part. Hydraulic pressure then automatically sequences, “freezing” the plunger, to properly support the part.

• Available in 8kN (M26) or 15.5kN (M35) capacity.
• Order with base or cartridge only.
• Ventless configuration and built in wipers protect the plunger movement from chips and debris.
• Base is compatible with Vektek’s In The Port Flow Control & In The Port Sequence Valves.
• Uses Vektek’s BHC technology to guard against corrosion.
• O-Ring face seal design makes machining cavities easier.

Standard G Series porting and alternate O-Ring manifold face seal is located in the base of the support flange for bolt down installation. Cartridge mount, 3 or 4 bolt flange options available.

 

High Capacity Part Present Sensing Work Supports!

Confirm part is present and contacted even on as-cast surfaces!

Plungers stay retracted during part loading while air flow travels through the work support. Hydraulic pressure advances the plunger exerting only spring force as it makes contact with the part. This closes the integral air valve to indicate part is present and contacted. Hydraulic pressure then automatically sequences, “freezing” the plunger.

• All the details stated above – plus…
• Once support is locked, air sensing positively confirms both contact and part present.
• Use Vektek’s Air Sensing Control Kit 45-0824-00 for easy setup.
•  Max air operating pressure is 1 bar.

 

Visit the Vektek Booth at the EMO at Hall 5, Stand G78